Dell PowerEdge C5230 - Manual (Page 130)

130 Troubleshooting
If the BIOS Setup Utility is accessible by pressing F2 during boot, reset the
BIOS to factory defaults by pressing F9. Save and exit the BIOS Setup (see
"Start Menu" on page 11 for more details).
If you cannot access the BIOS Setup Utility, clear the CMOS by performing
the following steps:
1 Turn off the system. Do not unplug the power cord.
2 Open the system.
3 Take the jumper and install on J18, covering pin1 and 2, then remove to
reset/clear CMOS.
4 Remove AC power.
5 Wait 5 seconds.
6 Move the jumper back to default position, covering pins 1 and 2.
7 Replace the chassis cover and turn on the system.
The CMOS is now cleared and can be reset by going into BIOS setup.
Viewing System Event Logs for Investigation
If the front panel LED blinks for 30 to 60 seconds upon applying AC power to
the power supply, the baseboard management controller (BMC) is
initializing. If not, then the BMC is not functioning. If the BMC is working,
try to gather system event log (SEL) information for investigation. For more
information, see "View System Event Log" on page 56.
Installation Problems
Perform the following checks if you are troubleshooting an installation
problem:
• Check all cable and power connections (including all rack cable
connections).
• Unplug the power cord, and wait one minute. Then reconnect the power
cord and try again.
• If the network is reporting an error, see if there is enough memory installed
and disk space available.