Dell Dimension 2100 - Manual (Page 72)

72 A d d i n g Pa r t s
www
.dell.com | support.dell.com
11 Connect a power cable to the drive.
NOTICE: When you attach the extra connector to the new drive in the
following step, match the colored strip on the cable with pin 1 on the drive.
12 If you didn’t install a controller card in step 10, remove the tape from
the wide cable connector and reattach the connector to the original
drive. Then locate the extra connector on the cable and attach it to the
new drive. Be sure that the wide cable is properly connected to the
IDE connector on the system board.
If you installed a controller card in step 10, attach the other end of the
interface cable to the controller card rather than to the system board.
power cable from
power supply
cable
pin 1