Troubleshooting your system, Safety first—for you and your system, Troubleshooting system memory – Dell PowerEdge VRTX User Manual
Page 55: 4 troubleshooting your system
4
Troubleshooting Your System
Safety First—For You and Your System
CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your
warranty. Read and follow the safety instructions that came with the product.
NOTE: For troubleshooting information on the Dell PowerEdge VRTX enclosure components, see “Troubleshooting
The Enclosure” in the
Dell PowerEdge VRTX Enclosure Owner's Manual
at dell.com/poweredgemanuals.
Troubleshooting System Memory
CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your
warranty. Read and follow the safety instructions that came with the product.
NOTE: Before performing the following procedure, ensure that you have installed the memory modules according
to the memory installation guidelines for the server module.
1.
Restart the server module:
a) Press the power button once to turn off the server module
b) Press the power button again to apply power to the server module.
If no error messages appear, go to step 8.
2.
Enter the System Setup and check the system memory setting.
If the amount of memory installed matches the system memory setting, go to step 8.
3.
Remove the server module from the enclosure.
4.
Open the server module.
CAUTION: The memory modules are hot to touch for some time after the server module has been powered
down. Allow time for the memory modules to cool before handling them. Handle the memory modules by the
card edges and avoid touching the components.
5.
Reseat the memory modules in their sockets.
6.
Close the server module.
7.
Install the server module in the enclosure.
8.
Run the appropriate diagnostic test. For more information, see Using System Diagnostics.
If the test fails, see
55