Dell PowerVault LTO3-060 - Manual (Page 64)

Packing the Autoloader
Gather the original packaging material to pack the autoloader: the shipping box, two foam end caps, accessory package insert (placed at the back of the unit),
and the antistatic bag. You will also need packing tape.
1. Place the antistatic bag over the autoloader.
2. Place one of the foam end caps onto each end of the autoloader. Place the second foam insert onto the other side of the autoloader and make sure the
pieces fit snugly onto the autoloader.
3. Place the autoloader into the shipping box and push the front of the autoloader towards the front end of the box.
4. Insert the accessory package insert at the back of the unit.
5. Place any necessary paperwork on top of the autoloader inside the box.
6. Close and seal the box.
7. Place the shipping label on the box.
Back to Contents Page
NOTE: The foam end caps are not identical. Refer to the diagram on the box flaps for proper orientation.
NOTE: The accessory package insert is to be placed at the back of the unit, not the front. Refer to the diagram on the box flaps for
proper orientation.