Dell PowerVault LTO3-060 - Manual (Page 58)

Front Panel Error Types
EA LCD Busy Error Possible LCD controller problem, software error, or communication error.
l Power cycle the autoloader.
l Run the Random Moves test.
l If all previous steps fail, see Contacting Dell .
EB LCD Goto Error
EC Login/Password Error Incorrect login from front panel.
l Use correct login/password.
ED Socket Error During SNTP
Barcode Error Types
F0 Bar Code Init Error l Remove magazines and inspect cartridges. Verify that valid barcode labels are being used on all
cartridges, and re-insert the magazines.
l If barcode labels are not being used, disable the barcode reader through the Operator Control Panel
or Remote Management Unit.
l Run the Random Moves test from either the Remote Management Unit (RMU) or the Operator Control
Panel (OCP).
Note: The Random Moves test requires a minimum of two cartridges present within the autoloader.
l If all previous steps fail, see Contacting Dell .
F1 Bar Code Hardware Error
F2 Bar Code Baud Rate Error
F3 Bar Code Handshake Error
F4 Bad/Noisy Response From Bar
Code Reader
F5 Checksum Failed Incomplete barcode label or barcode checksum failed.
l Repeat test with new cartridge or label.
l If problems recur with the original cartridge or label, replace.
l If all previous steps fail, see Contacting Dell .
F6 Barcode No Read Barcode label not present.
l Apply valid barcode label to cartridge, or disable the barcode reader through the Operator Control
Panel or Remote Management Unit.
F7 Barcode Mismatch Error l Power cycle the autoloader.
l Run the Random Moves test from either the Remote Management Unit (RMU) or the Operator Control
Panel (OCP).
Note: The Random Moves test requires a minimum of two cartridges present within the autoloader.
l If all previous steps fail, see Contacting Dell .
F8 Barcode Duplicate Label Error Duplicate barcode.
Diagnostic Error Types
F9 Diagnostic Test Failure l Power cycle the autoloader.
l Re-run the failing diagnostic test.
l If all previous steps fail, see Contacting Dell .
FA Diagnostic Error, Drive
Reporting Write Protect l Verify that valid, not data protected media is present for test.
l Run the Random Moves test from either the Remote Management Unit (RMU) or the Operator Control
Panel (OCP).
Note: The Random Moves test requires a minimum of two cartridges present within the autoloader.
l If all previous steps fail, see Contacting Dell .
FB Diagnostic Error, Cleaning Tape
Inserted
FC Diagnostic Load Tape Prompt This is a prompt to manually load a cartridge as required for test.
FD Diagnostic Unknown Tape
Format l Verify that valid, not data protected media is present for test.
l Run the Random Moves test from either the Remote Management Unit (RMU) or the Operator Control
Panel (OCP).
Note: The Random Moves test requires a minimum of two cartridges present within the autoloader.
l If all previous steps fail, see Contacting Dell .
FE Diagnostic Invalid Configuration This is an indication that a minimum of two pieces of media are required for test.
l Insure at least two cartridges are present in the autoloader and re-run the failed test.