Dell PowerVault LTO3-060 - Manual (Page 53)

l If the Random Moves test failed, see steps above for necessary actions.
l Power cycle the autoloader and re-run the failed test. See Contacting Dell if failure recurs.
Tape Drive Error Types
3A Drive Reset Error Check the TapeAlert log for more specific drive error information. Refer to Table 3 for recommended actions.
3B Drive HW Error
3C Drive Cleaning Required l Perform cleaning by loading a valid cleaning cartridge into the drive. If a slot is available to be
dedicated for a cleaning cartridge, this operation can be enabled to run automatically within the
Remote Management Unit Configuration page.
l Check the TapeAlert log for more specific drive error information. Refer to Table 3 for recommended
actions.
l If the drive continues to request cleaning, see Contacting Dell .
3D General Drive Error l Check the TapeAlert log for more specific drive error information. Refer to Table 3 for recommended
actions.
l If the drive is logging Read/Write errors, repeat the operation with new media.
l If the drive fails with two different pieces of media, see Contacting Dell .
3E Drive Load Error l Perform cleaning by loading a valid cleaning cartridge into the drive. If a slot is available to be
dedicated for a cleaning cartridge, this operation can be enabled to run automatically within the
Remote Management Unit Configuration page.
l Try to load a different piece of media.
l If the operation fails with two different pieces of media, see Contacting Dell .
3F Drive Unload Error
Drive/Media Error Types
40 Media Threading Error l Check the TapeAlert log for more specific drive error information. Refer to Table 3 for recommended
actions.
l Verify that a valid cartridge type is in use.
l Repeat operation with a new piece of media.
l If the operation fails with two different pieces of media, see Contacting Dell .
41 Media Unthreading Error
42 Media (MAM) Info Error
43 Invalid Media Type
44 Expired Cleaning Media
45 Unknown Media Error
46 Drive/Media Error
Miscellaneous Error Types
47 EEROM Chksum Error Contact support.dell.com .
48 Fan Sense Motion Error l Verify that the main fan is moving freely when the unit is on.
l If the previous step fails, see Contacting Dell.
49 Offline Diagnostics controlling system. No action required.
4A Host Lock Prevents Eject Host backup software has issued PREVENT/ALLOW MEDIUM REMOVAL command, often called a "lock" by the
host backup software.
l Issue an Unlock command through the host backup software, or power cycle the autoloader using the
Operator Control Panel power button to clear the lock setting.
4B Open Front All motor movement, including picker and magazine rotation, has been disabled for safety reasons.
l Verify the magazine or magazine blank is completely inserted on both the left and right sides of the
autoloader.
l Replace magazine or magazine blank (try a second one if possible).
l If the Random Moves test failed, see steps above for necessary actions.
l If all previous steps fail, see Contacting Dell .
4C Over Temp l Verify the temperature of the autoloader inlet air is within specification.
l Clear debris from all openings of the autoloader, both in front and back.
l Verify that the fan is working.
l If all previous steps fail, see Contacting Dell .
TCP/IP Stack and Task Error Types
50 IP Stack Panic l Verify that the autoloader is connected to the correct network.
l Verify that the network is properly configured (i.e. no loop-back condition exists). 51 IP Stack Memory Allocation