CH Tech EM405D - Manual (Page 43)

C-3
Table C-1. Wireless Ethernet Configuration Default Settings. (continued)
Advanced Serial Settings
Enable Port Logging False
Enable RTS Toggle False
Enable RCI over Serial (DSR) False
Send Socket ID False
Send data only under any of the following conditions True
- Send when data is present on the serial line False
- Send after the following number of idle milliseconds True - 12 ms
- Send after the following number of bytes 1024
- Close connection after the following number of idle
seconds False
- Close connection when DCD goes low False
- Close connection when DSR goes low False
GPIO
General Purpose Input/Output Pins
Pin 1 In
Pin 2 In
Pin 3 In
Pin 4 In
Pin 5 In
Alarms
Alarm Notification Settings
Enable Alarm Notifications False
Alarm Conditions
Alarm 1 …Alarm 32
False
Security
Administrator Password
Enable Password Authentication False
System
System Settings
Description blank
Contact blank
Location blank
Simple Network Management Protocol (SNMP) Settings
Enable Simple Network Management Protocol (SNMP) True
- Public community public
- Private community private
- Allow SNMP clients to set device settings through SNMP False
Enable Simple Network Management Protocol (SNMP) traps False