CH Tech EM405D - Manual (Page 41)

C-1
APPENDIX C – WIRELESS ETHERNET (Wi-Fi) DEFAULT SETTINGS
The Ethernet interface device on the Wireless version of the EM405D contains many
configurable settings that allow it to be used in a large number of applications. Many of these
settings must be set to certain values in order for the EM405D to operate normally. Other
settings are not applicable to the EM405D. When the user tries to configure the network settings
via the web-interface, he/she will see options to change many of these settings. Changing some
of these may make the EM405D inoperable. For this reason, it is highly recommended that the
user does not change any settings other than the following:
 
IP Address
 
Subnet Mask
 
Gateway Address
 
Wireless LAN Settings
 
Wireless Security Settings
Table C-1 lists the various settings and their default values as set my C&H during manufacturing
of the EM405D. If the carrier fails to operate, verify that these settings are set to their default
values prior to calling C&H for technical support. Settings that are emphasized in bold italics
are required settings that if changed will render the carrier inoperable.
Table C-1. Wireless Ethernet Configuration Default Settings.
Network
IP Settings
Obtain an IP address automatically using DHCP True
Wireless LAN Settings
Connect to wireless access points (infrastructure) True
Connect to any available wireless network True
Country United States
Channel Auto-Scan
Wireless Security Settings
Enable WEP security False
Enable WPA authentication False
Network Services Settings
Enable ADDP True
- Port 2362
Enable Encrypted RealPort True
- Port 1027
Enable HTTP & HTTPS True
- HTTP Port 80
- HTTPS Port 443