Cyclades PM IPDU - Manual (Page 57)

Chapter 4: Command Line Interface 45
Examples
To check the hardware overcurrent status of IPDU #1, enter the following.
To reset the hardware overcurrent protection, enter the following.
id
The id command sets or displays the ID of a PM IPDU. A maximum of 16 characters (not case
sensitive) is allowed. Spaces, numbers, and special characters are allowed. This command is
available to the administrator user only.
This command works in a daisy chain.
Syntax
id [] []
-or-
id [] []
-or-
id
Arguments
IPDU number in a daisy chain
Identification string previously set by the id command
If follows , or if the parameter is typed twice, the latest entry of
the parameter updates the ID string.
no argument Displays the IDs of all PM IPDUs in the daisy chain
Examples
To set the ID of PM IPDU 1 R&D, enter the following.
pm>hwocp 1
IPDU #1: HW overcurrent protection is OFF.
pm>hwocp 1 reset
IPDU #1 was reset
pm>id 1 R&D
IPDU #1: id = R&D