Dell PowerEdge 7250 - Manual (Page 81)

Terminal Mode Commands 79
BMC boot flag
valid bit clearing
(semi-volatile)
3 Data 1 - BMC boot flag valid bit clearing. Default = 0000b.
[7:5] - Reserved.
[4] - 1b = Do not clear valid bit on reset/power cycle caused by
PEF.
[3] - 1b = Do not automatically clear boot flag valid bit if IPMI
Chassis Control command not received within 60-second time-out
(countdown restarts when a IPMI Chassis Control command is
received).
[2] - 1b = Do not clear valid bit on reset/power cycle caused by
watchdog timeout.
[1] - 1b = Do not clear valid bit on pushbutton reset / soft-reset
(for example, --).
[0] - 1b = Do not clear valid bit on power up via power pushbutton
or wake event.
Table C-5. Boot Option Parameters (continued)
Parameter Number Parameter Data (non-volatile unless otherwise noted)