Dell POWEREDGE M1000E - Manual (Page 22)

12 EZSwitchSetup Administrator’s Guide
53-1002744-01
Installing and running the EZSwitchSetup wizard
2
If you are using an Ethernet LAN connection, a Discover Switch window is displayed ( Figure 7 ).
Proceed to “Discovering the switch.”
FIGURE 7 First Discover Switch window
Discovering the switch
1. Locate the WWN for your switch on the switch ID pull-out tab located on the bottom of the port
side of the switch.
2. From the Switch WWN list ( Figure 7 ), choose the switch’s WWN prefix numbers and then enter
the last six alphanumeric digits of your switch’s WWN. Each two alphanumeric digits must be
separated by a colon.
3. Click Next.
When EZSwitchSetup discovers the switch, it displays the discovered IP addresses (IPv4 and
IPv6), as shown in
Figure 8 .
If you are setting up the switch for the first time, the IP addresses are placeholder addresses
that were assigned at the factory and you must provide valid addresses.