beautypg.com

Before you begin, Recommended tools, Turning off your computer – Dell Inspiron 13 (1370, Late 2009) User Manual

Page 4: Before working inside your computer

background image

Back to Contents Page

 

Before You Begin

Dell™ Inspiron™ 1370 Service Manual 

  

Recommended Tools

  

Turning Off Your Computer

  

Before Working Inside Your Computer


This manual provides procedures for removing and installing components in your computer. Unless otherwise noted, each procedure assumes that the
following conditions exist:

l

 

You have performed the steps in

Turning Off Your Computer

and

Before Working Inside Your Computer

.

l

 

You have read the safety information that shipped with your computer.

l

 

A component can be replaced or—if purchased separately—installed by performing the removal procedure in the reverse order.

 

Recommended Tools

The procedures in this document may require the following tools:

l

 

small Phillips screwdriver

l

 

small flat-blade screwdriver

l

 

plastic scribe

l

 

BIOS executable update program available at support.dell.com

 

Turning Off Your Computer

 

 

1.

Save and close all open files and exit all open programs.

 

2.

Click Start

, then click Shut Down.

The computer turns off after the operating system shutdown process finishes.

 

3.

Ensure that the computer is turned off. If your computer did not automatically turn off when you shut down the operating system, press and hold the
power button until the computer turns off.

 

Before Working Inside Your Computer

Use the following safety guidelines to help protect your computer from potential damage and to help to ensure your own personal safety.

 

 

 

 

 

1.

Ensure that the work surface is flat and clean to prevent the computer cover from being scratched.

 

2.

Turn off your computer (see

Turning Off Your Computer

) and all attached devices.

 

CAUTION:

To avoid losing data, save and close all open files and exit all open programs before you turn off your computer.

WARNING:

Before working inside your computer, read the safety information that shipped with your computer. For additional safety best

practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.

CAUTION:

Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell is

not covered by your warranty.

CAUTION:

Handle components and cards with care. Do not touch the components or contacts on a card. Hold a card by its edges or by its metal

mounting bracket. Hold a component by its edges, not by its pins.

CAUTION:

When you disconnect a cable, pull on its connector or on its pull-tab, not on the cable itself. Some cables have connectors with locking

tabs; if you are disconnecting this type of cable, press in on the locking tabs before you disconnect the cable. As you pull connectors apart, keep
them evenly aligned to avoid bending any connector pins. Also, before you connect a cable, ensure that both connectors are correctly oriented
and aligned.

CAUTION:

To avoid damaging the computer, perform the following steps before you begin working inside the computer.