Dell Inspiron 13 (1370, Late 2009) - Manual (Page 17)

Replacing the Display Hinge Covers
1. Follow the procedures in Before You Begin .
2. Place the hinge covers on the display hinges, then snap the hinge covers into place.
3. Replace the display assembly (see Replacing the Display Assembly ).
4. Follow the instructions from step 5 to step 21 in Replacing the System Board .
5. Replace the battery (see Replacing the Battery ).
Display Bezel
Removing the Display Bezel
1. Follow the procedures in Before You Begin .
2. Follow the instructions from step 3 to step 15 in Removing the System Board .
3. Remove the display assembly (see Removing the Display Assembly ).
4. Remove the display hinge covers (see Removing the Display Hinge Covers ).
5. Remove the four rubber pads that cover the display bezel screws.
6. Remove the fours screws from the display bezel.
1 display assembly 2 hinge covers (2)
CAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.
CAUTION: The display bezel is extremely fragile. Be careful when removing it to prevent damaging the bezel.