Dell Inspiron 13 (1370, Late 2009) - Manual (Page 20)

3. Remove the display assembly (see Removing the Display Assembly ).
4. Remove the display hinge covers (see Removing the Display Hinge Covers ).
5. Remove the display bezel (see Removing the Display Bezel ).
6. Remove the display hinges (see Removing the Display Hinges ).
7. Remove the six screws that secure the display panel to the display cover.
8. Move the display panel down from the display cover enough to allow access to the camera cable.
9. Disconnect the camera cable from the camera module.
10. Remove the display panel from the display cover.
Replacing the Display Panel
1. Follow the procedures in Before You Begin .
2. Connect the camera cable to the connector on the camera module.
3. Align the display panel with the display cover using the alignment posts on the display cover.
4. Replace the six screws that secure the display panel to the display cover.
5. Replace the display hinges (see Replacing the Display Hinges ).
6. Replace the display bezel (see Replacing the Display Bezel ).
7. Replace the display hinge covers (see Replacing the Display Hinge Covers ).
8. Replace the display assembly (see Replacing the Display Assembly ).
9. Follow the instructions from step 5 to step 21 in Replacing the System Board .
10. Replace the battery (see Replacing the Battery ).
Back to Contents Page
1 screws (6) 2 display panel
3 camera module 4 camera cable
5 display cover
CAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.