beautypg.com

Safety instructions – Dell XPS 8300 (Late 2010) User Manual

Page 14

background image

14

Before You Begin

3 Ensure that the computer is turned off. If your computer did not

automatically turn off when you shut down the operating system, press

and hold the power button until the computer turns off.

Safety Instructions

Use the following safety guidelines to help protect your computer from

potential damage and to help ensure your own personal safety.

WARNING:

Before working inside your computer, read the safety information

that shipped with your computer. For additional safety best practices information,
see the Regulatory Compliance Homepage at
www.dell.com/regulatory_compliance.

CAUTION:

Only a certified service technician should perform repairs on your

computer. Damage due to servicing that is not authorized by Dell is not covered by
your warranty.

CAUTION:

When you disconnect a cable, pull on its connector or on its pull-tab,

not on the cable itself. Some cables have connectors with locking tabs; if you are
disconnecting this type of cable, press in on the locking tabs before you
disconnect the cable. As you pull connectors apart, keep them evenly aligned to
avoid bending any connector pins. Also, before you connect a cable, ensure that
both connectors are correctly oriented and aligned.

CAUTION:

To avoid damaging the computer, perform the following steps before

you begin working inside the computer.

1 Ensure that the work surface is flat and clean to prevent the computer

cover from being scratched.

2 Turn off your computer (see "Turning Off Your Computer" on page 13)

and all attached devices.

CAUTION:

To disconnect a network cable, first unplug the cable from your

computer and then unplug the cable from the network device.

3 Disconnect all telephone or network cables from the computer.
4 Disconnect your computer and all attached devices from their electrical

outlets.

5 Disconnect all attached devices from your computer.
6 Press and eject any installed cards from the Media Card Reader.
7 Press and hold the power button to ground the system board.

book.book Page 14 Wednesday, April 25, 2012 12:34 PM