Dell PowerEdge 1400SC - Manual (Page 61)

support.dell.com Using the System Setup Program 4-11
% &
! #
To delete or change an existing setup password, perform the following steps:
1. Enter the System Setup program and select the System Security screen option.
2. Highlight the Setup Password option and press the left- or right-arrow key to
delete the existing setup password.
The setting changes to Not Enabled.
3. If you want to assign a new setup password, perform the steps in the section
“Assigning a Setup Password” found earlier in this chapter.
If you forget your system or setup password, you cannot operate your system or
change settings in the System Setup program until a trained service technician opens
the computer chassis, changes the password jumper setting to disable the pass-
words, and erases the existing passwords. This procedure is described in Appendix B
of the Installation and Troubleshooting Guide.