Dell PowerEdge 1400SC - Manual (Page 38)

3-4 User’s Guide
This section provides information on installing the SCSI drivers for the Novell
NetWare 5.1 operating system. Instructions assume that NetWare 5.1 is installed and
operational.
NOTE: Use these procedures only if you did not use Server Setup from the Dell Open-
Manage Server Assistant CD to install your operating system.
!"#
$
If you have not already done so, use the Dell OpenManage Server Assistant CD to
create a NetWare 5.1 SCSI driver diskette.
If you are replacing an existing driver (for example, because it has become corrupted
or an upgrade has become available), you must first remove the installed driver. To
remove a driver, perform the following steps:
1. At the initial NetWare screen, press to display the NetWare console
screen.
2. At the server prompt, type nwconfig and press .
The NetWare Configuration screen appears, displaying the Configuration
Options menu.
3. At the Configuration Options menu, highlight Driver Options and press
.
4. At the Driver Options menu, highlight Configure disk and storage device
drivers and press .
5. At the Additional Driver Actions menu, highlight Unload an additional driver
and press .
6. At the Selected Disk Drivers menu, highlight the driver that you want to uninstall
and press .
7. At the message Driver xxx successfully unloaded , press .
The Additional Driver Actions menu appears.
From the Additional Driver Actions menu, you can repeat steps 5 through 7 to unin-
stall an additional driver, start with step 5 of the next procedure to install a driver, or
press to exit.