Dell PowerEdge 1400SC - Manual (Page 58)

4-8 User’s Guide
As you press each character key (or the spacebar key for a blank space), a place-
holder appears in the field.
The password assignment operation recognizes keys by their location on the key-
board without distinguishing between lowercase and uppercase characters. For
example, if you have an M in your password, the system recognizes either M or
m as correct. Certain key combinations are not valid. If you enter one of these
combinations, the speaker emits a beep. To erase a character when entering your
password, press the key or the left-arrow key.
NOTE: To escape from the field without assigning a system password, press the
key or the key combination to move to another field, or
press the key at any time prior to completing step 5.
4. Press .
If the new system password is less than seven characters, the whole field fills
with placeholders. Then the option heading changes to Verify Password, fol-
lowed by another empty seven-character field in square brackets.
5. To confirm your password, type it a second time and press .
The password setting changes to Enabled. Your system password is now set;
you can exit the System Setup program and begin using your system. Note,
however, that password protection does not take effect until you reboot the sys-
tem by turning the system off and then on again.
$#$
Whenever you turn on or reboot your system by pressing the key
combination, the following prompt appears on the screen when the Password Status
option is set to Unlocked:
Type in the password and... -- press to leave password
security enabled. -- press to disable password
security. Enter password:
If the Password Status option is set to Locked, the following prompt appears:
Type the password and press .
After you type the correct system password and press , your system boots
and you can use the keyboard or mouse to operate your system as usual.
NOTE: If you have assigned a setup password (see the section “Using the Setup
Password Feature” found later in this chapter), the system accepts your setup pass-
word as an alternate system password.
If a wrong or incomplete system password is entered, the following message appears:
** Incorrect password. **
Enter password:
If an incorrect or incomplete system password is entered again, the same message
appears.