Dell S510 Interactive Projector - Manual (Page 49)

Using Your Projector 49
1 Use
and
button to select IP Address, Subnet Mask,
Gateway, DNS, and Store.
2 Press the button to enter IP Address, Subnet Mask,
Gateway or DNS to set the value. (The selected option is
highlighted in blue)
a Use and button to select the option.
b Use and button to set the value.
c After the setup is complete, press the button to exit.
3 After the IP Address, Subnet Mask, Gateway, and DNS is set
up, select Store and press
button to store the settings.
4 If you select Store without pressing the Enter button, the
system will keep the original settings.
R ESET —Press to reset network configuration.
W IRELESS S ETTINGS — Select and press to activate wireless settings. The
wireless settings menu provides the following options:
DHCP S ERVER —Allows you to enable DHCP server of the wireless.
S TART IP A DDRESS —Automatically or manually assigns the Start IP
address of the DHCP server to the projector connected to the wireless.
E ND IP A DDRESS —Automatically or manually assigns the End IP address
of the DHCP server to the projector connected to the wireless.
S UBNET M ASK —Configure the Subnet Mask of the wireless connection.
G ATEWAY —Check the Gateway address with your network/system
administrator if you configure it manually.
DNS—Check the DNS Server IP address with your network/system
administrator if you configure it manually.
S TORE —Press to save the changes made in wireless configuration
settings.
NOTE: