Dell Dimension E520 User Manual
Page 92
92
Removing and Installing Parts
NOTICE:
To avoid damage to the drive, do not set it on a hard surface. Instead, set the drive on a surface, such as
a foam pad, that will sufficiently cushion it.
1 Check the documentation for the drive to verify that it is configured for your computer.
2 Follow the procedures in "Before You Begin" on page 59.
3 Press in on the blue release tabs on each side of the hard drive bracket and slide it up and out of the
computer.
4 Snap the bracket to the hard drive.
5 Gently slide the new drive (second hard drive) into place until you feel a click or feel the drive securely
installed.
6 Connect the power and hard-drive cables to the drive.
7 Ensure that the data cable is securely connected to the system board (see "System Board Components"
8 Check all connectors to be certain that they are properly cabled and firmly seated.
9 Replace the computer cover (see "Replacing the Computer Cover" on page 106).
NOTICE:
To connect a network cable, first plug the cable into the network port or device and then plug it into the
computer.
10 Connect your computer and devices to electrical outlets, and turn them on.
See the documentation that came with the drive for instructions on installing any software required for
drive operation.
1
release tabs (2)
2
second hard drive in lower
bay
3
hard drive bay
4
primary hard drive in upper
bay
1
2
3
4