Agp and dvi adapter cards, Removing a serial port adapter, Removing an agp or dvi adapter card – Dell OptiPlex GX260 User Manual

Page 92

1 card cage
2 serial adapter cable
3 serial adapter system board connector (SER2)

Removing a Serial Port Adapter

CAUTION:

Before you perform this procedure, see "

Precautionary Measures

1. Remove the card cage (see

in "Removing a PCI Card").

2. Press the lever on the retention arm and raise the retention arm.

3. Lift and remove the adapter bracket.

4. If you are removing the card permanently, install a filler bracket in the empty card-slot opening.

If you need a filler bracket, contact Dell.

NOTE:

Installing filler brackets over empty card-slot openings is necessary to maintain FCC certification of the

computer. The brackets also keep dust and dirt out of your computer.

5. Lower the retention arm and press it into place.

AGP and DVI Adapter Cards

Removing an AGP or DVI Adapter Card

1. Remove the filler bracket by raising the hinged lever and sliding the bracket up.

Press the indented tab on the hinged lever with your thumb until you release the tab. Continue holding the lever and

pull the lever up.

Filler Bracket Removal