Agp and dvi adapter cards – Dell OptiPlex GX260 User Manual
Page 33
5. Lower the retention arm into place, securing the card(s) in the computer (see "
").
Removing a Serial Port Adapter
CAUTION:
Before you perform this procedure, see "
."
1. Raise the retention arm.
2. Disconnect the cable from the system board connector.
3. Lift and remove the card bracket.
4. If you are removing the card permanently, install a filler bracket in the empty card-slot opening.
If you need a filler bracket, contact Dell.
NOTE:
Installing filler brackets over empty card-slot openings is necessary to maintain FCC certification of the
computer. The brackets also keep dust and dirt out of your computer.
5. Lower the retention arm and press it into place.
AGP and DVI Adapter Cards
CAUTION:
Before you perform this procedure, see "
."
Removing an AGP or DVI Adapter Card
1. Remove the filler bracket by raising the hinged lever and sliding the filler bracket up.
Filler Bracket Removal
1 hinged lever
2 filler bracket
2. On the card clip, press the card-clip lever toward the card slot.
3. Pull the card up and out of the card clip.