Serial port adapters, Installing a serial port adapter – Dell OptiPlex GX260 User Manual

Page 90

b. Make sure that the riser board is fully seated in the connector on the system board.

Replacing the Card Cage

1 card cage
2 tabs
3 slots

6. Reconnect any cables that you removed in

7. Connect any cables that should be attached to the card.

NOTICE:

Do not route card cables over or behind the cards. Cables routed over the cards can prevent the computer

cover from closing properly or cause damage to the equipment.

8. Close the computer cover.

9. Attach the computer stand (optional).

10. Install any drivers required for the card as described in the card documentation.

Serial Port Adapters

Installing a Serial Port Adapter

CAUTION:

Before you perform this procedure, see "

Precautionary Measures

1. Remove the card cage (see

in "Removing a PCI Card").

2. Press the lever on the retention arm and raise the retention arm.

3. Remove the filler bracket.

Raising the Retention Arm and Installing a Serial Port Adapter