Dell OptiPlex GX260 - Manual (Page 60)

Installing a Floppy Drive
1. If the replacement drive does not have the bracket rails attached, see step 2 in the previous section for instructions on
attaching rails.
2. Gently slide the drive into place until the tabs securely click into position.
3. Attach the power and floppy-drive cables to the floppy drive.
4. Connect the other end of the floppy-drive cable to the connector labeled DSKT on the system board.
Attaching Power and Drive Cables
1 power cable
2 floppy-drive cable
3 floppy-drive connector (DSKT)
5. If you are installing a new floppy drive rather than replacing a drive, remove the front-panel inserts.
6. Check all cable connections, and fold cables out of the way to provide airflow for the fan and cooling vents.
CD/DVD Drive
CAUTION: Before you perform this procedure, see " Precautionary Measures ."
Removing a CD/DVD Drive
1. Disconnect the power, audio, and CD/DVD drive cables from the back of the drive.
Removing Power, Audio, and Drive Cables