Dell Mellanox Family of Adapters User Manual

Page 67

Text mode
Original mode

User Manual for Mellanox ConnectX®-3 10/40 Gigabit Ethernet Adapters for Dell PowerEdge Servers

Rev 1.1

Mellanox Technologies

Step 6.

In the Advanced Storage Options window perform the following:

Step a.

Select the Add Iscsi Target option.

Step b.

Check the Bind targets to network interfaces checkbox.

Step c.

Click +Add drive button.

Step 7.

Enter the IP address of iSCSI target.

Optionally, you may choose to enter a customized Initiator Name and select the necessary
CHAP authentication of choice. Please refer to Section 5.1.1.3, “SAN-Booting the Disk-
less Client with FlexBoot,” on page 70 for further information.

In the example below, iSCSI Initiator Name is left with the default value given by the
installer and iSCSI discovery authentication is left with No authentication.

Step 8.

Check the relevant Node Name to log in.

If as a result of the discovery, multiple Node Names are found, select the one that is rele-
vant.