Dell Alienware 17 R2 (Early 2015) - Manual (Page 61)

Replacing the display
assembly
WARNING: Before working inside your computer, read the
safety information that shipped with your computer and
follow the steps in Before working inside your computer .
After working inside your computer, follow the instructions
in After working inside your computer . For more safety best
practices, see the Regulatory Compliance home page at
dell.com/regulatory_compliance.
Procedure
1 Align the screw holes on the display hinges with the screw holes on the
computer base.
2 Replace the screws that secure the display assembly to the computer
base.
3 Route the logo-board cable through the routing guide on the display hinge
and connect the logo-board cable to the system board.
4 Route the display cable through the routing guide on the display hinge.
5 Slide the display cable into the connector on the system board and press
down on the latch to secure the cable.
6 Route the antenna cables through the routing guide on the display hinge
and on the computer base.
7 Adhere the adhesive tapes that secure the antenna cables to the system
board.
8 Close the display and turn the computer over.
9 Replace the screws that secure the display assembly to the computer
base.
Post-requisites
1 Follow the procedure from step 5 to step 11 in “Replacing the palm rest ”.
2 Replace the wireless card .
3 Replace the base panel .
61