Replacing the display bezel, Procedure, Post-requisites – Dell Alienware 17 R2 (Early 2015) User Manual
Page 104

Replacing the display bezel
WARNING: Before working inside your computer, read the
safety information that shipped with your computer and
Before working inside your computer
.
After working inside your computer, follow the instructions
in
After working inside your computer
practices, see the Regulatory Compliance home page at
dell.com/regulatory_compliance.
Procedure
NOTE: This chapter is applicable only if you have purchased a laptop with
non-touchscreen display.
1
Adhere the logo board on the display bezel.
2 Connect the logo-board cable to the logo board and adhere the adhesive
tape.
3 Slide the display-board cables to their respective connectors on the logo
board and press down the latches to secure the cables.
4 Turn the display bezel over.
5 Align the display bezel with the display back-cover and gently snap the
display bezel into place.
Post-requisites
1
Replace the
2 Follow the procedure from step 5 to step 11 in “Replacing the
”.
3 Replace the
4 Replace the
.
104