Dell PowerEdge T110 II - Manual (Page 90)

90 Installing System Components
3 Remove the expansion-card stabilizer. See "Removing the Expansion-Card
Stabilizer" on page 78.
4 Remove the cooling shroud. See "Removing the Cooling Shroud" on
page 79.
5 Locate the memory module sockets. See Figure 6-1.
6 Remove the memory-module blanks from the sockets in which you plan to
install memory modules.
7 Press out the ejectors on each end of the socket until the memory-module
blank pops out of the socket. See Figure 3-17.
NOTE: Make sure to retain any removed memory-module blanks for future
use.
8 Handle each memory module only on either card edge, ensuring not to
touch the middle of the memory module.
9 Align the memory module's edge connector with the alignment key of the
memory module socket, and insert the memory module in the socket.
NOTE: The memory module socket has an alignment key that allows you to
install the memory module in the socket in only one way.
10 Press down on the memory module with your thumbs until the socket
levers latch into a locked position.
When the memory module is properly seated in the socket, the levers on
the memory module socket align with the levers on the other sockets that
have memory modules installed.
11 Repeat step 6 through step 10 of this procedure to install the remaining
memory modules. See Table 3-2.
12 Replace the expansion-card stabilizer. See "Installing the Expansion-Card
Stabilizer" on page 78.
13 Replace the cooling shroud. See "Installing the Cooling Shroud" on
page 80.
14 Close the system. See "Closing the System" on page 60.
15 Reconnect the system and peripherals to their power sources, and turn
them on.
16 Press to enter the System Setup program, and check the System
Memory setting on the main System Setup screen.
Coaster_HOM.book Page 90 Monday, November 3, 2014 3:23 PM