Dell PowerEdge T110 II - Manual (Page 83)

Installing System Components 83
4 Disconnect all cables from the card.
5 Open the expansion-card latch. See Figure 3-16.
6 Grasp the expansion card by its edges, and carefully remove it from the
expansion-card connector.
7 If you are removing the card permanently, install a metal filler bracket over
the empty expansion slot opening and close the expansion-card latch.
NOTE: Filler brackets must be installed over empty expansion card slots to
maintain Federal Communications Commission (FCC) certification of the
system. The brackets also keep dust and dirt out of the system and aid in
proper cooling and airflow inside the system.
8 Replace the expansion card stabilizer. See "Installing the Expansion-Card
Stabilizer" on page 78.
9 Close the system. See "Closing the System" on page 60.
10 Reconnect the system and peripherals to their power sources, and turn
them on.
11 Remove the card’s device driver from the operating system.
Coaster_HOM.book Page 83 Monday, November 3, 2014 3:23 PM