Power supply, Removing the power supply – Dell PowerEdge 1900 User Manual
Page 50
50
Installing System Components
Power Supply
Your system supports one power supply rated at an output of 800 W.
NOTICE:
To ensure proper system cooling, the power supply blank must be installed on the unoccupied power
supply bay.
Removing the Power Supply
1 Turn off the system and all attached peripherals.
2 Disconnect the power cable from the power outlet and the power supply, and remove the cable
from the cable retention bracket.
3 Open the system. See "Opening the System" on page 48.
4 Remove the expansion-bay and processor-cooling fans (FAN1, FAN2, and FAN3). See "Removing and
5 Remove the center fan bracket. See "Removing the Center Fan Bracket" on page 79.
6 Disconnect the power cables from the following components where applicable (see Figure 6-2 for
connector locations):
•
PWR1 connector on the system board
•
PWR2 connector on the system board
•
PWR CTRL connector on the system board
•
Hard drives
•
Diskette drive
•
Optical drive
•
Tape backup unit
•
Cable retention clips on the chassis (see Figure 3-4)
7 Remove the four screws securing the power supply to the back panel. See Figure 3-4.
8 Slide the power supply from the system.