Dell XPS 410 (Mid 2007) - Manual (Page 52)

52
Troubleshooting Tools
Dell Diagnostics
CAUTION:
Before you perform any of the procedures in this section, follow the safety instructions in the
Product Information Guide.
If you experience a problem with your computer, perform the checks in "Solving Problems" on page 61
and run the Dell Diagnostics before you contact Dell for technical assistance.
NOTE:
The Dell Diagnostics only operate on Dell computers.
1 Turn on (or restart) your computer.
2 When the DELL logo appears, press immediately.
If you wait too long and the operating system logo appears, continue to wait until you see the
Microsoft
®
Windows
®
desktop, then shut down your computer and try again.
3 When the boot device list appears, highlight Boot to Utility Partition, then press .
4 When the Dell Diagnostics Main Menu appears, select the test you want to run.
The system is operating in quick resume
mode. See "Using Intel
®
Viiv™ Quick
Resume Technology (QRT)" on page 46
for additional information.
• Press the power button
• Move the mouse
• Press any key on the keyboard
• Press any key on the optional MCE
remote control
• If the problem persists, contact Dell
(see "Contacting Dell" on page 137).
Another failure has occurred. • Ensure that all hard drive and
CD/DVD cables are properly
connected to the system board (see
"System Board Components" on
page 81).
• If there is an error message on your
screen identifying a problem with a
device (such as the floppy drive or hard
drive), check the device to ensure that
it is functioning properly.
• If the operating system is attempting to
boot from a device (such as the floppy
drive or hard drive), check system setup
(see "System Setup" on page 127) to
ensure the boot sequence is correct for
the devices installed on your computer.
• If the problem persists, contact Dell
(see "Contacting Dell" on page 137).
Light Pattern Problem Description Suggested Resolution