Dell XPS 410 (Mid 2007) - Manual (Page 107)

Removing and Installing Parts
107
9 Check all connectors to be certain that they are properly cabled and firmly seated.
10 Replace the computer cover (see "Replacing the Computer Cover" on page 121).
NOTICE:
To connect a network cable, first plug the cable in to the network wall jack and then plug the cable into
the computer.
11 Connect your computer and devices to electrical outlets, and then turn them on.
12 If installing this drive changes the drive configuration, then be sure to reflect these changes in the
BIOS. When you restart your computer, enter system setup (see "System Setup" on page 127). Then,
go to the "Drives" section of the BIOS and under
SATA 0 through 5 , set the SATA ports to the
correct configuration.
See the documentation that came with the hard drive for instructions about installing any software
required for the operation of the hard drive.
Adding a Second Hard Drive
CAUTION:
Before you perform any of the procedures in this section, follow the safety instructions in the Product
Information Guide.
CAUTION:
To guard against electrical shock, always unplug your computer from the electrical outlet before
opening the cover.
NOTICE:
To avoid damage to the drive, do not set it on a hard surface. Instead, set the drive on a surface, such as
a foam pad, that will sufficiently cushion it.
1 Check the documentation for the drive to verify that it is configured for your computer.
2 Follow the procedures in "Before You Begin" on page 77.
1 power cable 2 hard drive cable
2
1