General installation guidelines, Hard drive – Dell XPS 410 (Mid 2007) User Manual
Page 104

104
Removing and Installing Parts
General Installation Guidelines
Connect the hard drives to the connectors labeled "SATA0" and "SATA1", starting with SATA0. Connect
CD/DVD drives to the connectors labeled "SATA4" or "SATA5", starting with SATA4.
Serial ATA hard drives and CD/DVD drives are connected to the connectors labeled "SATA0" to "SATA5"
on the system board.
When connecting and disconnecting a serial ATA cable, hold the cable by the connector at each end.
Hard Drive
CAUTION:
Before you perform any of the procedures in this section, follow the safety instructions in the Product
Information Guide.
CAUTION:
To guard against electrical shock, always unplug your computer from the electrical outlet before
opening the cover.
NOTICE:
To avoid damage to the drive, do not set it on a hard surface. Instead, set the drive on a surface, such as
a foam pad, that will sufficiently cushion it.
If you are replacing a hard drive that contains data, back up your files before you begin this procedure