Dell Latitude CPi A - Manual (Page 207)

Shared RAM Test
Performs a memory test on controllers with memory-mapped shared RAM. On controllers with first-in
first-out (FIFO) shared RAM, writes a data pattern to all locations and reads the pattern back to verify
the operation. Some controllers do not support shared RAM tests.
Display Information Test
Displays address and configuration information about the network controller. This information includes
the network address used for communication on the local area network (LAN) and the controller's IRQ
level. You can make sure there is not an interrupt conflict by verifying that the IRQ level is not being
used by another device connected to the system.
Audio Test Group
The subtests in the Audio test group check the functions of the audio controller and the computer's recording
and playback features.
Why Run an Audio Test
If you do not hear sounds from your built-in speakers when you expect to, it is possible that your operating
system or sound application uses resource settings different from those of the audio controller in the
computer. In the absence of an expected sound, first check the documentation that accompanied your
operating system or sound application to see if the sound features are correctly configured to work with the
computer. The default resource settings for the audio controller are:
DMA channel: 1
IRQ line: 5
Port address: 220h
If necessary, change the resource settings in your operating system or sound application to match these
default settings.
If you still do not hear sound when you expect to, run the Audio test group.
NOTE: Before running the Audio test group, enable the built-in speaker(s) to make sure that the
speaker volume has not been muted.
Subtests
The six subtests in the Audio test group confirm the following functions:
Software Reset Test
Checks for the presence of an active audio controller in your system
Interrupt Test
Checks whether the audio controller is generating an interrupt on the IRQ line configured for that
controller