Dell Latitude CPi A - Manual (Page 107)

drivers.
Installing System Utilities
System utilities let you configure features such as the asset tag code and suspend-to-disk partition.
To copy the system utilities to your hard-disk drive, perform the following steps.
NOTE: You can also run the system utilities directly from the System Utilities diskette.
1. Insert the System Utilities diskette into the diskette drive.
2. Copy each of the utilities on the System Utilities diskette to the c:\dell directory on your hard-disk
drive. The utilities have the following filenames: mks2d.exe, rms2d.exe, asset.com, and readme.s2d.
For more information on copying files in Windows 95, see the documentation that came with the
operating system.
After you copy the utilities to your hard-disk drive, you must restart your computer in the MS-DOS
®
mode to
use the utilities.
See the readme.s2d file for more information on using the suspend-to-disk partition utilities. For more
information on using the asset tag utility, see your Dell system documentation.
Installing the Software Wavetable
The software wavetable allows you to customize certain audio features. To install the software wavetable,
perform the following steps:
1. Save your work in all open application programs, because you will need to restart your computer at the
end of this procedure to complete the installation.
2. Insert the first software wavetable diskette into the diskette drive.
3. Click the Start button, and then click Run... .
The Run dialog box appears.
4. Type a:\setup and then click OK or press to install the utility on your hard-disk drive.
5. Follow the instructions on your screen.
6. After the installation is complete, remove the final diskette from the diskette drive and restart your
computer to use the software wavetable.
Back to Contents Page