Power-button board, Removing the power-button board – Dell Inspiron One 2320 (Mid 2011) User Manual
Page 97
Antenna-In Connector
97
23
Power-Button Board
WARNING:
Before working inside your computer, read the safety information
that shipped with your computer. For additional safety best practices information,
see the Regulatory Compliance Homepage at
www.dell.com/regulatory_compliance.
CAUTION:
Only a certified service technician should perform repairs on your
computer. Damage due to servicing that is not authorized by Dell is not covered by
your warranty.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist
grounding strap or by periodically touching an unpainted metal surface (such as a
connector on your computer).
Removing the Power-Button Board
1 Follow the instructions in "Before You Begin" on page 11.
2 Remove the back cover. See "Removing the Back Cover" on page 19.
3 Remove the rear-stand assembly. See "Removing the Rear-Stand Assembly"
4 Remove the rear I/O cover. See "Removing the Rear I/O Cover" on page 39.
5 Remove the side I/O cover. See "Removing the Side I/O Cover" on page 41.
6 Remove the system-board shield. See "Removing the System-Board
7 Remove the screw that secures the power-button board to the chassis.
8 Disconnect the power button and hard-drive activity light cable from the
connectors on the power-button board, the AV board, and the system
board.
9 Slide and lift the power-button board along with its cable away from the
chassis.
book.book Page 97 Thursday, May 3, 2012 1:21 PM