Antenna-in connector, Removing the antenna-in connector – Dell Inspiron One 2320 (Mid 2011) User Manual
Page 89
Antenna-In Connector
89
21
Antenna-In Connector
WARNING:
Before working inside your computer, read the safety information
that shipped with your computer. For additional safety best practices information,
see the Regulatory Compliance Homepage at
www.dell.com/regulatory_compliance.
CAUTION:
Only a certified service technician should perform repairs on your
computer. Damage due to servicing that is not authorized by Dell is not covered by
your warranty.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist
grounding strap or by periodically touching an unpainted metal surface (such as a
connector on your computer).
Removing the Antenna-In Connector
1 Follow the instructions in "Before You Begin" on page 11.
2 Remove the back cover. See "Removing the Back Cover" on page 19.
3 Remove the rear-stand assembly. See "Removing the Rear-Stand Assembly"
4 Remove the rear I/O cover. See "Removing the Rear I/O Cover" on page 39.
5 Remove the side I/O cover. See "Removing the Side I/O Cover" on page 41.
6 Remove the system-board shield. See "Removing the System-Board
7 Remove the two screws that secure the antenna-in connector to the
chassis.
8 Disconnect the antenna-in cable from the connector on the Mini-Card.
9 Slide and lift the antenna-in connector along with its cable away from the
chassis.
book.book Page 89 Thursday, May 3, 2012 1:21 PM