Processor, Removing the processor – Dell Inspiron One 2320 (Mid 2011) User Manual
Page 83
Processor
83
20
Processor
WARNING:
Before working inside your computer, read the safety information that
shipped with your computer. For additional safety best practices information, see
the Regulatory Compliance Homepage at dell.com/regulatory_compliance.
CAUTION:
Only a certified service technician should perform repairs on your
computer. Damage due to servicing that is not authorized by Dell is not covered by
your warranty.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist
grounding strap or by periodically touching an unpainted metal surface (such as a
connector on your computer).
Removing the Processor
1 Follow the instructions in "Before You Begin" on page 11.
2 Remove the back cover. See "Removing the Back Cover" on page 19.
3 Remove the rear-stand assembly. See "Removing the Rear-Stand Assembly"
4 Remove the rear I/O cover. See "Removing the Rear I/O Cover" on page 39.
5 Remove the side I/O cover. See "Removing the Side I/O Cover" on page 41.
6 Remove the system-board shield. See "Removing the System-Board
7 Remove the processor heat-sink. See "Removing the Processor Heat-Sink"
8 Press the release lever down on the processor cover and then pull it
outwards to release it from the tab that secures it.
9 Extend the release lever completely to open the processor cover.
Leave the release lever extended in the release position so that the socket is
ready for the new processor.
book.book Page 83 Thursday, May 3, 2012 1:21 PM