Dell PowerVault DR2000v - Manual (Page 33)

ID Issue Description Workaround/Solution
14897 OST limiter throughput
below the set value. The throttling speed
limits that can be set
using the DR Series
system CLI
commands
(replication --
limit --speed)
would not match the
set replication
bandwidth limits. Corrected some minor issues with the OST
limits to correct this issue.
14889 Add the option to the
CLI to show if the
SNMP Trap’s email is
on or off. Added additional
option to alerts
--show –email
command.
Email SNMP
Trap's : Yes
or No
Added additional option to alerts --
show –email command to show status of
Trap’s e-mail.
14845 system --upgrade
command fails with an
error
message:Upgrade
image not found. After replacing a
hardware CRU or
FRU, the DR may
come up in support
mode with a request
to upgrade the
hardware. The GUI and CLI now place the uploaded SW
package into the same directory so upon HW
replacement this same image can be utilized
to upgrade the new component when
necessary with no special user action
required.
14724 Replication speed limits
not throttling as
expected. The throttling speed
limits that can be set
using the DR Series
system CLI
commands
(replication --
limit --speed)
would not match the
set replication
bandwidth limits. Corrected some minor issues with the
replication limits to correct this issue.
13537 Dell DR4100 system
enclosure hot add fails
in Release 2.0. Attempting to
perform a "hot add" of
an external
expansion shelf
enclosure in a
DR4000 or DR4100
system fails because
this is not a
supported method of
operation in the 2.0
product release. To
prevent this error/ The workaround is to observe the following
best practice for connecting an external
expansion shelf enclosure to a Release 2.0
DR4000 or DR4100 system:
• Power off the DR4000 or DR4100 system
(this is a requirement for 2.0 with Dell
OpenManage 7.1).
• Connect the cabling between the external
expansion shelf enclosure and the
DR4000 or DR4100 system.
• Power on the external expansion shelf
enclosure.
33