Dell Inspiron 1420 (Mid 2007) - Manual (Page 5)

Back to Contents Page
Internal Card With Bluetooth® Wireless Technology
Dell™ Inspiron™ 1420/Dell Vostro™ 1400 Service Manual
Removing and Replacing Internal Card With Bluetooth® Wireless Technology
Removing and Replacing Internal Card With Bluetooth® Wireless Technology
If you ordered an internal card with Bluetooth wireless technology with your computer, it is already installed.
1. Follow the procedures in Before You Begin .
2. Remove the memory module cover (see Memory ).
3. Loosen the captive screw to remove the card carrier.
4. Gently slide the card out from underneath the metal clips.
5. Lift the card from the compartment, ensuring that you do not pull on the card cable with excessive force.
6. Disconnect the card from the card cable.
7. Connect the replacement card to the card cable.
8. Slide the card underneath the metal clips.
9. Tighten the captive screw to secure the card carrier.
Back to Contents Page
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
NOTICE: To help prevent damage to the system board, you must remove the battery from the battery bay before you begin working inside the
computer.
CAUTION: Before performing the following procedures, follow the safety instructions in your Product Information Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching a connector on the back panel of
the computer.
1 metal clip 2 internal card with Bluetooth wireless technology 3 captive screw
NOTICE: Be careful when removing the card to avoid damaging the card, card cable, or surrounding components.