Dell XPS 730x H2C (Early 2009) - Manual (Page 16)

16
Setting up Your Computer
network
adapter
connectors
(2) Use the network adapter connector to attach your
computer to a network or broadband device.
Connect one end of a network cable to either a network
jack or your network or broadband device, and then
connect the other end of the network cable to the
network adapter connector on your computer.
A click indicates that the network cable has been
securely attached.
NOTE:
It is recommended that you use Category 5 wiring
and connectors for your network. If you must use Category
3 wiring, force the network speed to 10 Mbps to ensure
reliable operation.
1 - network
activity LED Flashes a yellow light when the computer is transmitting
or receiving network data. A high volume of network
traffic may make this LED appear to be in a steady
"on" state.
2 - link
integrity
LED • Green — A good connection exists between a 10-Mbps
network and the computer.
• Orange — A good connection exists between
a 100-Mbps network and the computer.
• Yellow — A good connection exists between
a 1000-Mbps (1-Gbps) network and the computer.
• Off (no light) — The computer is not detecting a
physical connection to the network.
USB 2.0
connectors
(6) Use the back USB connectors for devices that typically
remain connected, such as printers and keyboards.
NOTE:
It is recommended that you use the front USB
connectors for devices that you connect occasionally, such
as flash memory keys, cameras, or bootable USB devices.
eSATA
connector Use to connect additional storage devices.
1
2
book.book Page 16 Monday, November 10, 2008 1:26 PM