Dell 3000cn Color Laser Printer - Manual (Page 25)

Asset Tag Number Specifies the asset tag number.
EWS
Settings
Auto Refresh On Refreshes the contents of the status display pages automatically.
Off Does not refresh the status display pages automatically.
Auto Refresh
Interval
Sets the time interval for refreshing the contents of the status display pages automatically
from 15 to 600 seconds.
NOTE: The auto refresh feature is effective for the contents of the Top Frame, Printer Status page, Job List page,
and Completed Jobs page.
Port Settings
Purpose:
To specify whether to enable or disable printing ports and management protocol features.
Values:
Ethernet Ethernet
Settings
Auto Detects Ethernet transmission rate and the duplex settings automatically.
10BASE-T Half-
Duplex
Selects 10Base-T Half-Duplex as the default value.
10BASE-T Full-
Duplex
Selects 10Base-T Full-Duplex as the default value.
100BASE-TX
Half-Duplex
Selects 100Base-T Half-Duplex as the default value.
100BASE-TX Full-
Duplex
Selects 100Base-T Full-Duplex as the default value.
Current Ethernet Settings Displays the current settings of Ethernet.
MAC Address Displays the printer's MAC address.
Port
Settings
LPD Select the check box to enable the LPD.
Port9100 Select the check box to enable the Port9100.
FTP Select the check box to enable the FTP port.
E-Mail Alert Select the check box to enable the E-Mail Alert feature.
SNMP Agent Select the check box to enable the SNMP.
You can also configure the transport protocol to be used. UDP can be
selected as the transport protocol.
NOTE: The settings in the Port Settings item will be valid only when the printer is rebooted. When you change or set
this item, click the Restart printer to apply new settings. button to apply new settings.
TCP/IP
Purpose:
To configure the IP address, subnet mask, and gateway address of the printer.
Values: