Dell Inspiron One 19 Touch (Late 2009) - Manual (Page 13)

Back to Contents Page
Coin-Cell Battery
Dell™ Inspiron™ One 19 Service Manual
Removing the Coin-Cell Battery
Replacing the Coin-Cell Battery
Removing the Coin-Cell Battery
1. Record all the screens in system setup utility (see System Setup Utility ) so that you can restore the correct settings in step 14 .
2. Follow the procedures in Before You Begin .
3. Remove the I/O cover (see Removing the I/O Cover ).
4. Remove the computer stand (see Removing the Computer Stand ).
5. Remove the optical drive (see Removing the Optical Drive ).
6. Remove the decorative cover (see Removing the Decorative Cover ).
7. Remove the speaker cover (see Removing the Speaker Cover ).
8. Remove the display bezel (see Removing the Display Bezel ).
9. Remove the back cover (see Removing the Back Cover ).
10. Remove the I/O bracket (see Removing the I/O Bracket ).
11. Remove the inverter (see Removing the Inverter ).
12. Remove the system-board shield (see Removing the System-Board Shield ).
13. Carefully pull the release lever away from the coin-cell battery and lift the coin-cell battery out of the socket.
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
WARNING: A new battery can explode if it is incorrectly installed. Replace the battery only with the same or equivalent type recommended by the
manufacturer. Discard used batteries according to the manufacturer's instructions.
CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
1 coin-cell battery 2 release lever