Cisco 1040 - Manual (Page 6)

6
Selecting and Configuring a Cisco Catalyst Switch
Note Cisco 1040 should be installed on the Cisco switch nearest the IP telephones that are being
monitored.
To connect the Cisco 1040, you need a Cisco Catalyst switch with the following:
• A port that supports IEEE 802.3af standard Power over Ethernet (PoE).
Note To use inline power on a Cisco Catalyst 3550, you must configure the port from the
command line using this Cisco IOS command:
power inline delay shutdown 20 initial 30
For more information on Cisco Catalyst command reference guides, see Related
Documentation, page 12.
• A port that is configured as a SPAN or RSPAN destination port for:
– Ports to which phones are connected
– VLANs
For information about configuring SPAN and RSPAN on Cisco Catalyst switches and modules,
see the following URL.
http://www.cisco.com/en/US/products/hw/switches/ps700/products_tech_note09186a008015c61
2.shtml.
UDP 69 TFTP—Cisco 1040 uses TFTP to get a configuration file and
binary image file.
UDP 514 Syslog—Cisco 1040 sends syslog messages to Service Monitor.
TCP 2000 SCCP—Cisco 1040 uses SCCP to communicate with Service
Monitor.
TCP 80 http—Cisco 1040 has a web-based user interface to view its
configuration
Table 1 Cisco 1040 Port Usage (continued)
Protocol Port Number Service Name