Cisco Linksys SPA9000 - Manual (Page 69)

3-3
Linksys SPA9000 Administrator Guide
Document Version 3.01
Chapter 3 Configuring Voice Service and Voicemail
Using the Wizard to Configure ITSP Voice Services and Voicemail
Figure 3-3 Configuring the ITSP Voice Service
Step 5 Configure the options on this page as directed by the Internet Telephony Service Provider (ITSP).
The following describes the purpose of each parameter on this page.
• Proxy—Enter the fully qualified domain name of the SIP proxy server for all outbound requests.
This modifies the parameter on the NAT Settings section of the Line tab on the
administration web server.
Note If you use the administration web server to change the configuration of a parameter, using the
Wizard again may overwrite your changes. To avoid this, either rerun the Wizard to change your
configuration, or do not use the Wizard after using the administration web server.
• Outbound Proxy—Enter the fully qualified domain name of a SIP outbound proxy server where all
outbound requests are sent as the first hop. This modifies the parameter.
• Enable NAT Keep Alive—If you enter yes, the configured is sent
periodically every seconds. This modifies the
parameter.
• NAT Keep Alive Interval— Enter an integer to determine the interval in seconds between
NAT-mapping keep alive messages. The default is 15. This modifies the
Enable> parameter.
• NAT Keep Alive Message—Enter the contents of the keep-alive message to be sent to a given
destination periodically to maintain the current NAT-mapping. This can be an empty string. If value
is $NOTIFY, a NOTIFY message is sent as keep alive. If value is $REGISTER, a REGISTER
message without Contact is sent. This modifies the parameter.
• NAT Keep Alive Destination—Enter the fully qualified domain name of the destination to send NAT
keep alive messages. If the value is $PROXY, it is sent to the current proxy or outbound proxy. This
modifies the parameter.
• User ID—Enter the value provided by your ITSP.
• Password—Enter the value provided by your ITSP.
• Display Name—This is the string that is used for displaying Caller ID information.
• Auth ID—Enter the SIP authentication ID if this is required by your ITSP.