Cisco Linksys SPA9000 - Manual (Page 41)

2-11
Linksys SPA9000 Administrator Guide
Document Version 3.01
Chapter 2 Getting Started
Using the Interactive Voice Response Interface
Note The items marked with “Requires Password” only require a password if the Administrator password is
set.
Set Primary DNS Server 161 Enter IP address using
numbers on the telephone
key pad. Use the * (star) key
when entering a decimal
point. Requires password
Check administration web
server port 170 None IVR announces the port that the web
server is listening on. (Default is 80)
Check LAN IP Address 210 None IVR announces the current IP address of
the LAN port.
Check PBX multicast
address 180 None IVR announces the current value.
Set PBX multicast
address 181 Enter IP address and port.
Use * key for entering a dot.
For example,
224.168.168.169:8089 is
224*168*168*169*8089. Enter a * between the IP address and the
Port fields. Requires Password
Enable/Disable
administration web server 7932 Enter 1 to enable
Enter 0 to disable
Requires password
Manual Reboot of Unit 732668 None After you hear “Option Successful,” hang
up. Unit reboots automatically.
User Factory Reset of
Unit
WARNING:
ALL “User-Changeable”
NON-DEFAULT
SETTINGS WILL BE
LOST!
This might include
network and service
provider data.
877778 Enter 1 to confirm
Enter *(star) to cancel
operation
SPA prompts for confirmation. After
confirming, you hear “Option
Successful.” Hang up. Unit reboots and
all “User Changeable” configuration
parameters are reset to factory default
values.
Factory Reset of Unit
WARNING:
ALL NON-DEFAULT
SETTINGS WILL BE
LOST!
This includes network and
service provider data.
73738 Enter 1 to confirm
Enter * (star) to cancel
operation
SPA prompts for confirmation. After
confirming, you hear “Option
Successful.” Hang up. Unit reboots and
all configuration parameters are reset to
factory default values.
Table 2-2 IVR Options (continued)