Cisco Linksys SPA9000 - Manual (Page 177)

6-29
Linksys SPA9000 Administrator Guide
Document Version 3.01
Chapter 6 SPA9000 Field Reference
Regional Tab
Vertical Service Activation Codes
Vertical Service Activation Codes are automatically appended to the dial-plan. There is no
need to include them in dial-plan, although no harm is done if they are included.
CPC Delay Delay in seconds after caller hangs up when the SPA9000 starts removing the tip-and-ring
voltage to the attached equipment of the called party. Range: 0–255 seconds. SPA9000
has had polarity reversal feature since release 1.0 which can be applied to both the caller
and the callee end. This feature is generally used for answer supervision on the caller side
to signal to the attached equipment when the call has been connected (remote end has
answered) or disconnected (remote end has hung up). This feature should be disabled for
the called party (in other words, by using the same polarity for connected and idle state)
and the CPC feature should be used instead.
Without CPC enabled, reorder tone will is played after a configurable delay.
If CPC is enabled, dial tone will be played when tip-to-ring voltage is restored
Resolution is 1 second.
The default is 2.
CPC Duration Duration in seconds for which the tip-to-ring voltage is removed after the caller hangs up.
After that, tip-to-ring voltage is restored and dial tone applies if the attached equipment
is still off-hook. CPC is disabled if this value is set to 0. Range: 0 to 1.000 second.
Resolution is 0.001 second.
The default is 0 (CPC disabled).
Field Description
Call Return Code This code calls the last caller.
The default is *69.
Call Redial Code Redials the last number called. (Not in PAP2T)
The default is *07.
Blind Transfer Code Begins a blind transfer of the current call to the extension specified after the activation
code.
The default is *98.
Call Back Act Code Starts a callback when the last outbound call is not busy.
The default is *66.
Call Back Deact Code Cancels a callback.
The default is *86.
Call Back Busy Act Code Starts a callback when the last outbound call is busy. (Not in PAP2T)
The default is *05
Cfwd All Act Code Forwards all calls to the extension specified after the activation code.
The default is *72.