Casio PV-S460/PV-S660 - Manual (Page 131)

129
Chapter 11 Data Communication
To make communication parameter settings
1. After connecting the two units, turn on the PV Unit.
2. Display the list view in a mode whose data can be received with this
setup.
• This configuration supports receipt of Contacts, Memo, Schedule and
To Do data.
• REMINDER 1, REMINDER 2, EXPENSE, CALENDAR, SKETCH,
and FREE FILE data cannot be received.
3. On the screen that appears, tap Menu Bar to display the menu bar, and
then tap System – Data communication.
4. Tap the button next to SF/CSF/NX.
5. Press the button next to Set up parameters and then tap Set.
6. On the screen that appears, tap the buttons under Parity, Bit length, and
BPS to make the settings you want.
• Note that the settings you make here must match those of the connected
SF/CSF/NX Series Unit. Otherwise, proper data communication will be
impossible.
7. After making all the settings you want, press Set to register them, and
return to the screen in step 4, above.
• Now you can continue with the following data receive procedure.
To receive data from an SF/CSF/NX Series Unit
1. After connecting the two units, turn on the PV Unit.
2. Display the list view in a mode whose data can be received with this
setup.
• This configuration supports receipt of Contacts, Memo, Schedule and
To Do data.
• REMINDER 1, REMINDER 2, EXPENSE, CALENDAR, SKETCH,
and FREE FILE data cannot be received.
3. Tap Menu Bar to display the menu bar, and then tap System – Data
communication .