Acronis Backup Advanced for vCloud - Quick Start Guide - Manual (Page 8)

8 Copyright © Acronis International GmbH, 2002-2014
Note You can use an existing RabbitMQ Server user account with permissions equal to or higher than those
given by the commands above.
Acronis Backup Advanced for vCloud Agent for vCloud will use this account to receive event
notifications from vCloud Director. Remember the account credentials, as you will be asked for
them when configuring Agent for vCloud.
6. Open a web browser and go to the RabbitMQ Server Web UI located at: http://
name>:15672/. Here, is the address of the RabbitMQ Server host.
7. Provide the credentials of the RabbitMQ Server user created in step 5.
8. Click Exchanges.
9. Under Add a new exchange:
a. In Name, specify a name for a new exchange that will be used by Agent for vCloud. For
example, specify vcdExchange.
b. In Type, select topic.
c. Leave the default values for all other settings.
d. Click Add exchange.
10. Log in as an administrator to vCloud Director.
11. Click Administration.
12. Under System settings, click Extensibility.
13. Under Notifications, select the Enable notifications check box.
14. Under AMQP Broker Settings:
a. In AMQP Host, specify the name or IP address of the RabbitMQ Server host.
b. In AMQP Port, type 5672.
c. In Exchange, specify the name of the new exchange that you created in step 9.
d. In vHost, type /.
e. In Prefix, type vcd.
f. In User Name and Password, type the credentials of the user account created in step 5.
15. Click Apply.
5.2 Installing Acronis Backup Advanced for vCloud
5.2.1 Installing the management server
1. On the machine that will act as the management server, log on as an administrator.
2. Start the Acronis Backup Advanced setup program.