Baumer N 140 - Manual (Page 18)

N 140
www.baumer.com 18
7. Technical data
Technical data – electrical ratings
Supply voltage
24 VDC ±10 %
Current consumption ≤30 mA
Display LCD, 7-segment display, 2-lines, backlit
Measuring principle Absolute multiturn sensing
Measuring range -999,99...+9999,99 mm
-99.999...+999.999 inch
Steps per turn 2304
Number of turns 4096 / 12 bit
Spindle pitch ≤23 mm
Interface RS485 (ASCII-protocol)
Data memory Parameter buffer: EEPROM
Current value buffer: >10 years by
integrated 3 V lithium battery
Programmable parameters Display position horizontal/vertical
Measuring unit mm/inch
Counting direction
Spindle pitch
Spindle tolerances
Positioning direction
Direction arrows
Tolerance window
Round up/down
Standard DIN EN 61010-1 Protection II
Overvoltage category II
Pollution degree 2
Emitted interference DIN EN 61000-6-3
Interference immunity DIN EN 61000-6-2
Approvals UL/cUL
Technical data – mechanical design
Hollow shaft
ø20 mm, ø25 mm
Operating speed ≤600 rpm (short-term)
Protection DIN EN 60529 IP 65 (housing), IP 40 (connector)
Operating temperature -10...+50 °C
Storage temperature -20...+70 °C
Relative humidity 80 % not condensing
Torque support Torque pin provided at housing
E-connection - Cable output (30 cm) with male and mating connector M16, 5-pins
Housing type Surface-mount with hollow shaft
Dimensions W x H x L 56 x 100 x 62.5 mm
Mounting Surface-mount with hollow shaft
Weight approx. 200 g
Material Polycarbonate black, UL 94V-0